(1) Before using the machine, must read the product manual carefully, and according to the stipulation to carry on the adjustment and the maintenance. Before the boot should check the meter screen, rice knife, drum core, Mi Mi cover, such as whether the damage, is installed, the parts of the bolts, nuts are screwed, the bearing is lack of lubricating oil, rotating spindle (drum) check whether or not stuck.
(2) Before the use of rice milling machine to pay attention to the suitability of power matching, power refers to the power and speed. The selection of power is mainly based on the calibration of the marking machine nameplate on the numerical matching; Rotate speed through the pulley to choose, so that the meter machine has the appropriate speed, not to arbitrarily improve the spindle speed.
(3) Regular cleaning of rice milling machine exports of bran, to maintain smooth export. If the fine bran mixed with rice and the whole rice, should immediately check whether the rice screen damaged leakage, and take appropriate measures.
(4) The user who has not purchased the safety protection device shall, before the product is put into use, configure the safety protective device according to the standard.
(5) Prohibited iron, stone and other sundries into the rice milling room, lest cause blockage or damage to the meter sieve.
(6) The machine should have grounding protection to prevent electric shock. When the rice milling machine is running, it is forbidden to open the safety shield. Before normal operation, should be transported by air to 3 5min, confirmed that no abnormal phenomenon, the party can feed the operation. When not in the hopper, it is strictly prohibited to use the hand or the iron bar to help feed.
(7) In the work should be constantly check the transmission belt and screw fastening conditions and bearing temperature, lubrication, found that abnormal conditions must be immediately shut down to check, strictly prohibit the machine running when troubleshooting.
(8) A minor, drunken person suffering from a disease affecting judgment may not operate the machine.
(9) In the operation of the meter machine normal, into the hopper filled with rice gradually opened the export of the Board, and observe the accuracy of grain, rice, broken Valley whether meet the requirements. If not, adjust the spacing between the outlet inserts or the rice knives. In the precision, rice, broken Valley to meet the requirements of the case, as far as possible open large import board, until full load.
(10) In the milling, is to put the grain into the rice mill of the white indoor, using the roller rotation to the grain pressure, so that the grain of rice. The greater the pressure, the higher the grinding accuracy. If you want to grind white at a time, it will increase the rice rate because of the excessive pressure, and if the pressure is too small, it will appear uneven, the chaff is not clean, there will be a small amount of grain. Therefore, must divide two or three times to grind the white, can reduce the rice, enhances the meter rate and the milled the white precision.
